Cimatron It V12.2 
-----------------


1) When prompted during installation enter the following codes:

KeyCode : 

61874,11520,62466,1308757,1308765,1261841,19820,19812,55705,1285566,1285558,1265424
ID : 5555

UG : 9999 9999 9999 9999 9999 9999 9999 9999

CATIA : 8888 8888 8888 8888 8888 8888 8888 8888

RE_ENGE : 24904


2) After installation copy over uggeo.dll, dlvgeo.dll to /bin dir, and interact.dll to /var/moldbase3d/dll dir.

3) Install the custom HASP drivers. Please read the 
   "HASP Driver End User Manual by CrackZ.pdf" located in the /RiSE HASP Driver dir.
3) 安装HASP DRIVERS,在CRACK\Cimatron IT\CRACK\RiSE Hasp Driver\目录下,进入MS-DOS状态,
先敲hinstall -r 来移走原本的HASP DRIVER,再敲hinstall -i,来装新的HASP DRIVERS
再运行这目录里的Cimatron it v12.2 & CimatronE.reg,将内容添加到注册表,
再将Haspnt.sys拷贝到X:\WINNT\SYSTEM32下及X:\WINNT\SYSTEM32\drivers下,覆盖同名文件.
这时可以重新启动了,CIMATRON12.2就能用了